Winston Industries PF56C Manuel de service télécharger pdf (Page 155)

17.

Replace the four (4) screws securing

vent assembly to rear of fryer.

NOTE:

Vent tube must protrude

through vent assembly at least l/2"

(See Figure 16).

18.

Connect the two (2) solenoid wires

to harness wires.

19.

Place O-ring over vent tube and

slide back against vent assembly.

CAUTION:

Prior to applying final torque

solenoid wires are not pinched

between nut plate and vent

assembly. This could create

a shorted circuit causing potential

equipment damage

and/or

personal

injury.

20.

Place vent block on vent tube, line up nut plate behind vent assembly and replace the four

(4) screws securing block onto vent tube and vent assembly.

21.

Drop vent ball (if applicable) down through waffle onto vent block.

22.

Place weight down in weight lifter.

23.

Place vent back onto vent assembly.

24.

Replace the seven (7) screws securing back panel and Danger Label panel to rear of fryer.

25.

Place muffler onto vent back and place unit back into service.

REPLACE

COTTER

(ITEM NO.

60)

Tools:

Phillips Screwdriver

#2;

Needle Nose Pliers.

DANGER:

Turn off electrical power and disconnect electrical power supply. If unit is

hardwired, CIRCUIT BREAKER MUST BE OFF.

CAUTION: Utilize care when removing muffler in Stop 3. Muffler may contain very

hot water.

2. Remove muffler and place in sink.

to screws in Step 20, verify

FIG. 16

Procedure:

WINSTON

LIT.6710/REV.0/9-91

1 2 ... 150 151 152 153 154 155 156 157 158 159 160 ... 306 307

Commentaires sur ces manuels

Pas de commentaire

Winston Industries PF56C Manuel de service Page 155

Commentaires sur ces manuels

Produits connexes et manuels pour Friteuses Winston Industries PF56C