Winston Industries PF56C Manuel de service Page 172
- Page / 307
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
CAUTION:
Utilize care in performing Step 6. Due to location and amount of torque required
to remove nuts, wear gloves for protection in the case of wrench slipping.
6.
Remove the three (3) nuts securing front block to top of fryer. Remove defective front
block.
7.
Remove any residue of old silicone sealant from top of fryer.
3.
Apply silicone sealant to entire base of new front block and mount on fryer. Place lock
washers on bolts end tighten the three (3) nuts securing front block to fryer.
9.
Replace the four (4) screws securing relay panel to side panels.
10.
Replace the four (4) screws securing escutcheon to relay panel.
11.
Replace the two (2) screws securing eyebrow to relay panel and place unit back into service.
REPLACE MAIN CIRCUIT BOARD
Tools: Phillips Screwdriver #2; Nut Driver -11/32”
Procedure:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
DANGER:
Turn off electrical power, disconnect electrical power supply, drain shortening
and allow to cool. If unit is herdwired, CIRCUIT BREAKER MUST BE OFF.
Remove the two (2) screws securing eyebrow to relay panel and save for reuse.
Remove the four (4) screws securing escutcheon to relay panel and save for reuse. Lower
escutcheon slowly until secure in open position.
Unplug the 15 pin molex connector from circuit board.
Remove the four (4) nuts securing circuit board to esctcheon.
CAUTION: Pull circuit board back from escutcheon slowly until membrane panel con-
nector strip is visible. Unplug strip from circuit board.
Plug strip into new circuit board. NOTE: Verify pins in strip align properly with pins in
circuit board.
Replace the four (4) nuts securing new circuit board to escutcheon.
Plug molex connector into circuit board.
Replace the four (4) screws securing escutcheon to relay panel.
Replace the two (2) screws securing eyebrow to rolay panel.
NOTE: Progrmming of new circuit board may be required. Verify programming in each
channel prior to placing unit back into service.
WINSTON
59
LIT.6710/REV.0/9-91
- Commodore Thermalizer 3
- 8 Lit. #4275T155 – 7/98 10
- Breader/Sifter 11
- WINSTON BREADER/SIFTER 12
- Hot Foods Merchandiser 17
- Wiring Schematic 25
- ‘D’ SERIES 26
- BACK INTERIOR ASSEMBLY 28
- BOTTOM ASSEMBLY 29
- TANK ASSEMBLY 30
- PROBE ASSEMBLIES 31
- CABINET ASSEMBLY 32
- DRAWER CABINET ASSEMBLY 33
- DRAWER ASSEMBLY 34
- ESCUTCHEON CONTROL ASSEMBLY 35
- ‘N’ SERIES 38
- CABINET & DRAWER ASSEMBLY 43
- ESCUTCHEON / CONTROL ASSEMBLY 44
- PROBE ASSEMBLY 46
- HBK, L, M, 8, 0 or 5 49
- SCHEMATIC 60
- PF46C and PF56C 61
- Pressure Fryer 61
- DELTA Configuration 70
- WYE Configuration 71
- Parts Identification Manual 72
- Lit. #4275R99 - 11/96 87
- WINSTON COLLECTRAMATIC FRYER 100
- Parts Identification 100
- Collectramatic 102
- Table of Contents 103
- SERVICE MANUAL 114
- INTRODUCTION 115
- TABLE OF CONTENTS 116
- (Behind) 119
- (If Applicable) 119
- (Inside) 120
- PARTS IDENTIFICATION 122
- TROUBLESHOOTING 127
- REMEDIES 129
- AMPERAGE/OHM VALUE CHARTS 130
- WIRING DIAGRAM 131
- REPLACE MERCURY RELAY 139
- (ITEM NO. 48) 140
- (ITEM NO. 52) 140
- (ITEM N0. 47) 141
- REPLACE HEATER (ITEM N0.34) 142
- (ITEM N0. 54) 144
- REPLACE PROBE (ITEM NO. 36) 145
- (ITEM NO.55) 147
- (ITEM NO. 6) 147
- REPLACE LID LOCK ASSEMBLY 148
- REPLACE LID VALVE ASSEMBLY 149
- REPLACE HANDLE BAR 149
- REPLACE FUSE (ITEM NO. 53) 150
- REPLACE WHEEL (ITEM NO. 25) 151
- (ITEM NO. 62) 153
- REPLACE 155
- REPLACE VENT TUBE O-RING 157
- (ITEM NO. 61) 159
- (ITEM NO. 56) 160
- REPLACE WEIGHT 162
- (ITEM NO. 58) 164
- Remove the 165
- (ITEM NO. 59) 166
- Procedure: 168
- DANGER: 168
- (ITEM NO. 10, 11, 19) 169
- REPLACE VENT BLOCK (ITEM NO 170
- CAUTION: 171
- REPLACE MAIN CIRCUIT BOARD 172
- OBTAINING SERVICE 173
- Shortening Filter 174
- WINSTON SHORTENING FILTER 175
- Holding Cabinet 207
- HA4522 CABINET NP ASM 209
- CVAP Holding/Proofing Cabinet 214
- (Surface-mounted controls) 234
- LIT 6529 243
- Winston CVAP Brand 288
- Drawer Cabinet 296
Produits connexes et manuels pour Friteuses Winston Industries PF56C
(2 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.629 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels